Spread is zero
Spread is zero
The historic gbpusd with 20of spread, but when I test makes me the test with 0 spread.
Re: Spread is zero
Hi Pabluru,
Please check out our release notes for Tickstory v1.7.4. which describes a workaround for working with a spread issue in MT4 Build 950:
https://tickstory.com/articles/tickstor ... -released/
Regards.
Please check out our release notes for Tickstory v1.7.4. which describes a workaround for working with a spread issue in MT4 Build 950:
https://tickstory.com/articles/tickstor ... -released/
Regards.
Re: Spread is zero
Ok, Thanks and works well.
This problem is fixed for other versions?
This problem is fixed for other versions?
Re: Spread is zero
Hi Pabluru,
Good to hear it working. The issue affects Builds 920-950 (950 being the last build that was released).
Regards.
Good to hear it working. The issue affects Builds 920-950 (950 being the last build that was released).
Regards.
-
- Posts: 14
- Joined: Thu Apr 07, 2016 11:05 am
Spread is zero
Dear tickstory,
In build 950, the spread doesn't seem to be shown. I have tried a solution you offered (start the backtest with control points and then stop it and restart it with tick modelling method) but still does not seem to work. Could I see the spread in the mt4 during the test, or just when the test is done? Every settings is set right in the mt4 for the spread to be shown, but still cannot see it. Could you offer any other solution, I'd be very grateful.
Thank you and regards,
Szabolcs
In build 950, the spread doesn't seem to be shown. I have tried a solution you offered (start the backtest with control points and then stop it and restart it with tick modelling method) but still does not seem to work. Could I see the spread in the mt4 during the test, or just when the test is done? Every settings is set right in the mt4 for the spread to be shown, but still cannot see it. Could you offer any other solution, I'd be very grateful.
Thank you and regards,
Szabolcs
Re: Spread is zero
Hi Szabolcs,
I assume you've explicitly set the spread in the Strategy Tester 'spread' box? Make sure it is not set to 'Current' and instead set to a specific value. Do you see the correc the spread showing when you back-test in 'Control points' mode? If not, how are you verifying the spread value?
Thanks.
I assume you've explicitly set the spread in the Strategy Tester 'spread' box? Make sure it is not set to 'Current' and instead set to a specific value. Do you see the correc the spread showing when you back-test in 'Control points' mode? If not, how are you verifying the spread value?
Thanks.